It was Leigh Wilcox, proprietor of the now-defunct Airgun Express, who memorably said to me several years ago: “Fun targets fall down, break, or bleed.”
And he was right. While I enjoy shooting at paper targets, there are times when I just crave to shoot at a target that does something when a pellet clobbers it fair and square.
Recently the good folks at www.airgunsofarizona.com sent me a large box with a bunch of goodies in it. In addition to a bunch of packing peanuts, there were several air pistols and, at the very bottom, a largish green box that said “Remington Airgun Target.” It also said, “Auto reset,” which I don’t think is exactly correct, but we’ll get to that in a little while.
Remington manufactures a line of airgun targets. The one that I was sent was a metal silhouette of a wild boar with a 12-inch heavy metal spike attached. The target is very similar to the targets used in field target competition, but it isn’t quite the same. Field targets are designed with a hole – the kill zone – at some location on the face plate of the target. There is a paddle behind the hole, and when a pellet passes through the kill zone and hits the paddle, the target falls down. The target must then be pulled upright using a long string that is attached to the face plate of the target.
The Remington wild boar resettable target that I was sent has a metal face plate with a hole in it, and behind the kill zone is a paddle. But when a pellet hits the paddle, the entire target does not fall down. Instead, the paddle tilts backwards, and it is clearly visible to the shooter that the paddle is no longer behind the kill zone. To reset the target, the airgunner must shoot the second paddle which is hanging below the face plate. When that paddle is struck with a pellet, it causes the first paddle – the one behind the kill zone – to pop back up to its upright position.
So while the Remington resettable target is not exactly “automatic” – that is, it doesn’t reset itself without any intervention from the shooter – it does reset without having to pull a string. As another part of the package says, it is a “shoot-to-reset target.” As such, it saves the shooter from the hassle of having to lay out up to 50 yards of string (depending, of course, on the distance) and having to wind it all back up again, as you would with a conventional field target.
What makes the Remington resettable target particularly appealing is that offers the shooter the ability to vary the size of the kill zone. The basic size of the kill zone is 1.5 inches, but there are two metal inserts that can be rotated into the kill zone to reduce its size to 1 inch or .5 inch.
This target is intended only for use with lead pellets, and several places on the package it says that it is not to be used with non-lead pellets or BBs because of the risk of ricochet. There is one very curious note on the package. It says: “Minimum distance: .177 cal 1000+ fps 25 yards, .22 cal 800+ fps 35 yards. Presumably this is to prevent damage to the target which would probably take the form of dents to the metal. I would guess that most airgunners would find hitting a half-inch kill zone at 35 yards pretty challenging. I know that I would.
The Remington resettable target doesn’t come with any written instructions that I could find, but its use is pretty straightforward. After a while, however, the face plate and the paddles will become smeared with gray lead from the pellets so that eventually it will become difficult to see the paddle clearly behind the kill zone. When that happens, a little spray paint – flat black for the faceplate and yellow for the paddles – will make everything visible again.
The Remington resettable target is simply a lot of fun. If you are an airgunner, you need one of these. It will put a grin on your face.
Til next time, aim true and shoot straight.
– Jock Elliott