The handsome – and accurate – FX T12 FT – Part II

Monday, April 23, 2012

 

I find the FX FT very pleasing to the eye.

To ready the FX T12 FT for shooting, attach the filling probe to your high pressure pump or SCUBA tank and charge the reservoir to 200 BAR.

To load the magazine, begin by turning the transparent lid to the magazine counterclockwise until it stops. Put one pellet in the open slot on the rear (black) side of the magazine so that the tip of the pellet is pointing out of the hole. This locks the magazine spring in place.

Next, turn the magazine so that the transparent lid is facing you. Turn the lid clockwise one slot at a time and fill the slots with pellets with the tip of the pellets facing into the hole. When all the slots have been filled, slide the lid back into its starting position.

Pull the bolt lever all the way back and insert the magazine, black side toward the muzzle, into the breech from the right side. When setting up the FX T12 FT, make sure the scope mounts are high enough that no part of the scope interferes with the magazine sliding fully into place. If you are purchasing an FX T12 FT and scope from Airguns of Arizona, the good folks there can make sure you have the proper height scope rings.

 

The trigger is light and crisp.

Now you are ready to shoot. Push the bolt forward, flick off the safety, and squeeze the trigger. The first stage required only 10.4 ounces of pressure on the sample that I tested. At 1 lb. 4.4 oz., the shot went down range. This is an excellent trigger that is a pleasure to shoot, and while it is adjustable, I really can’t imagine why anyone wouldn’t be delighted with the trigger just as it comes from the factory.

The built-in moderator subdues the report of the FX FT.

The FX T12 FT launches 18.2. JSB pellets at average of 836 fps, or 28.1 foot-pounds of energy at the muzzle  and delivers 50 shots per fill with a 35 fps spread. Even with the built-in barrel, there is a significant POP when the shot goes off, but it is not nearly as raucous as one would typically expect from a .22 caliber PCP generating this kind of power. Still, this is not the air rifle you want to be shooting in the back yard while your neighbor is catching up on his sleep from the night shift. But this a hunting gun and out in the field the report should be just fine.

I have yet to test an FX rifle that was anything but a tackdriver, and the FX T12 FT is no exception. At 13 yards, from a casual rest, the FX T12 FT will put pellet after pellet through the same hole. At 30 yards with JSB pellets and fitful winds, I put 5 shots into a group that measured just .625 inch edge to edge. That works out to well under half an inch center to center.

The FX T12 FT is a handsome air rifle that shoots as good as it looks. It should put a smile on the face of any air rifle enthusiast.

Til next time, aim true and shoot straight.

– Jock Elliott

2 Comments

  1. chris bruce says:

    Jock, did you like t-12 better than the gladi8tor? I have a gladi8tor and was thinking of trading it for a t-12, I think it is one of fx better looking rifles. Not a big fan of the bottle on the gladi8tor. thanks CB.

    1. Jock Elliott says:

      CB,

      I like the looks of the T12, but I love the high shot count of the Gladi8tor.

Leave a Reply

four × 5 =